Cisco UCS 6454 Installation Manual page 47

Replacing Components
Retrieving config from peer Fabric interconnect... done
Installer has determined that the peer Fabric Interconnect is
running a different firmware version than the local Fabric.
Cannot join cluster.
Local Fabric Interconnect
Peer Fabric Interconnect
Do you wish to update firmware on this Fabric Interconnect to the
Peer's version? (y/n): y
Updating firmware of Fabric Interconnect.......
[ Please don't press Ctrl+c while updating firmware ]
Updating images
Please wait for firmware update to complete.
<output truncated>
Install has been successful.
Firmware Updation Successfully Completed. Please wait to enter the IP address
Peer Fabric interconnect Mgmt0 IPv4 Address: xx.xx.xx.xx
Peer Fabric interconnect Mgmt0 IPv4 Netmask: xx.xx.xx.xx
Cluster IPv4 address
Peer FI is IPv4 Cluster enabled. Please Provide Local
Fabric Interconnect Mgmt0 IPv4 Address
Physical Switch Mgmt0 IP address : xx.xx.xx.xx
Apply and save the configuration (select 'no' if you want to re-enter)?
(yes/no): yes
Applying configuration. Please wait.
Fri Dec
Configuration file - Ok
Step 14
Enter the show cluster extended-state command to revalidate the cluster state and verify that HA is ready.
Example:
FI-A# show cluster extended-state
Cluster Id: 0x537d0580bf9911e0-0x8955000decd07984
A: UP, PRIMARY
B: UP, SUBORDINATE
A: memb state UP, lead state PRIMARY, mgmt services state: UP
B: memb state UP, lead state SUBORDINATE, mgmt services state: UP
heartbeat state PRIMARY_OK
INTERNAL NETWORK INTERFACES:
eth1, UP
eth2, UP
HA READY
UCSM version : 3.1(2c)
Kernel version : 5.0(3)N2(3.12b)
System version : 5.0(3)N2(3.12b)
local_model_no : UCS-FI-6454
UCSM version : 3.1(2c)
Kernel version : 5.0(3)N2(3.12c)
System version : 5.0(3)N2(3.12c)
peer_model_no : UCS-FI-6454
9 19:57:15 UTC 2016
<<<<<<<<<<<<<←---------------- HA is READY
: xx.xx.xx.xx
Cisco UCS 6454 Fabric Interconnect Hardware Installation Guide
Replacing a Fabric Interconnect
41