Table of Contents
Advertisement
Click Save when done.
3.
CONFIGURING STATIC IP ADDRESSES FOR THE
NETWORK PORTS
During the initial boot setup process for the DGX-2 System, you had an opportunity to
configure static IP addresses for a single network interface. If you did not set this up at
that time, you can configure the static IP addresses from the Ubuntu command line
using the following instructions.
Note: If you cannot access the DGX-2 System remotely, then connect a display
(1440x900 or lower resolution) and keyboard directly to the DGX-2 System.
Determine the port designation that you want to configure, based on the physical
1.
ethernet port that you have connected to your network.
DGX-2 System User Guide
Network Configuration
36
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DGX-2 SYSTEM and is the answer not in the manual?
Questions and answers