Timer Operation (On Timer/Off Timer/Weekly Timer) - Fujitsu Airstage UTB- LB Series Operating Manual

TIMER OPERATION (ON timer/OFF timer/Weekly timer)

Instructions relating to heating are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
The timer function cannot be used when the remote controller is a slave unit. (For information concerning the slave unit, refer
to the INSTALLATION INSTRUCTION SHEET of the remote controller.)
To set the ON/OFF timer
1
Select either "OFF TIMER" or "ON TIMER".
→ → →
NON STOP OFF
(RESET) TIMER
To cancel the TIMER mode during
TIMER operation
Press the TIMER MODE button and set the display to "NON
STOP" (the unit will switch to continuous operation).
To set the WEEKLY timer (For information concerning the WEEKLY TIMER function, refer to p. 7, "OPERATING TIPS.")
* Press the START/STOP button to stop the air conditioner, and then proceed as follows.
1
Select .
3
Press for 3 seconds.
(The "WEEKLY 1" ON time starts flashing.)
5
(The day display changes to the set temperature display.)
7
10
(The "WEEKLY 2" ON time starts flashing.)
* If the settings are complete, proceed to step
12
Press the TEMP./DAY button to select another day
and repeat steps
→
ON WEEKLY
TIMER TIMER
8
(The "WEEKLY 1" OFF time starts
flashing.)
13
.
4 11
to to set another day.
2
Set the on or off time.
Press repeatedly to adjust the time in 1-minute increments.
Press continuously to adjust the time in 10-minute incre-
ments.
To stop or start operation during use of
TIMER mode
Press the START/STOP button.
2
Select the number that corresponds to the selected day in-
dicated by a code from 1 to 7.
4
Set the "WEEKLY 1" ON time.
Press repeatedly to adjust the time in 5-minute increments.
Press continuously to adjust the time in 10-minute incre-
ments.
6
Select the desired operation mode.
Set the desired temperature.
9
Set the "WEEKLY 1" OFF time.
11
Repeat steps
(Return to the "WEEKLY 1" ON time by pressing
the SET button.)
→ →
WEEKLY 1 WEEKLY 1
ON OFF
* If the settings are complete, proceed to step
13
Press for 3 seconds.
("WEEKLY" flashes for 3 seconds, then the clock display
reappears.)
En-3
4 10
to to set "WEEKLY 2".
→ →
WEEKLY 2 WEEKLY 2
ON OFF
13
.