Page 1
INSTALLATION MANUAL SIMPLE REMOTE CONTROLLER (Without operation mode) For authorized service personnel only. MANUEL D'INSTALLATION TÉLÉCOMMANDE SIMPLE (Sans le mode de fonctionnement) Uniquement réservé aux techniciens agréés. MANUAL DE INSTALACIÓN MANDO A DISTANCIA SIMPLE (Sin modo de funcionamiento) Sólo para personal de servicio autorizado. UTY-RHKU PART NO.
INSTALLATION MANUAL Do not install the unit in the following areas: PART NO. 9371068138 • Do not install the unit near a source of heat, steam, or SIMPLE REMOTE CONTROLLER (Without operation mode) fl ammable gas. • Area fi lled with mineral oil or containing a large amount of Contents splashed oil or steam, such as a kitchen.
2. MAIN UNIT AND ACCESSORIES 4. SELECTING AN INSTALLATION LOCATION The following installation parts are supplied. Use them as required. 4.1. Dimensions Name of Shape Q’ty Application Simple remote Main unit controller Unit : in. (mm) 2-15/16 (75) 9/16 1-15/16 (49) 2-3/8 (60) (14) hole ×...
CAUTION 5. INSTALLING THE REMOTE When performing wiring work, be careful not to damage CONTROLLER the cable or injure yourself. Also, connect the connectors securely. Loose connectors will cause trouble, heating, fi re, or electric shock. WARNING Install the power supply cable and remote controller Always use the accessories and specifi...
Modify the cable as per below methods. 6. INSTALLATION METHODS (1) Use a tool to cut off the terminal on the end of the remote controller cable, and then remove the insulation from the cut 6.1. Group control end of the cable as shown in Fig. 1. (2) Connect the remote controller cable and connecting cable (1) Wiring method (indoor unit to remote controller) as shown in Fig.
(2) Remote controller DIP switch setting 8. ADDRESS SETTING Set the remote controller DIP switch No. 2 according to the following table. Address setting method of indoor unit can be selected from Master unit Slave unit Number of remote 3 options (outdoor unit, indoor unit and remote controller). controllers DIP switch No.
Page 8
(4) When the “Address data” blinks by pressing the Refrigerant circuit address setting “ ” button set the Indoor unit address data (6) When the “Address code” blinks set the Address code by pressing the “ ” button or “ ”...
Completion of address setting mode Function number and setting number setting (3) “Function number” display blinks. Then display Number by (9) Address setting mode is released and returns to normal pressing the “ ” button or “ ” button. display if the “ ”...
Completion of address setting mode 12. ERROR CODE DISPLAY (6) Function setting mode is released and returns to normal If there is a problem with the air conditioner, it will stop running display if the “ ” button, “ ” button and “...
Need help?
Do you have a question about the AIRSTAGE UTY-RHKU and is the answer not in the manual?
Questions and answers