Golden Technologies GP162 Owner's Manual page 18

Arm Width Adjustment
1. Loosen the adjustment screw at the rear of the seat with a 4mm Allen wrench.
See figure 8.
2. Slide the arm in or out to the desired width.
3. Tighten the adjustment screw to secure the arm.
4. Repeat steps 1-3 to adjust the opposite arm.
Note: The backrest can be folded down to minimize chair height during transport.
Adjustment Bolt
(5mm Allen)
Armrest Angle Adjustment
1. Lift armrest up. See figure 9.
2. Turn jam nut clockwise to loosen.
3. Turn the adjustment bolt to raise or lower the armrest-angle. Turning the bolt
clockwise will raise the angle. Turning the bolt counter-clockwise will lower the angle.
Turn until desired angle is reached.
4. Retighten jam nut by turning it counter-clockwise.
5. Repeat steps 1-4 to adjust the opposite armrest.
VI. COMFORT SETTINGS
Figure 8
Figure 9
Adjustment Screw
(4mm Allen)
18
Jam Nut
(14mm)