Figure 8 Installing The Peripheral Drive - Quantum NDX Series User Manual

Figure 8 Installing the
Peripheral Drive
Quantum NDX NAS Tower User's Guide
3 Unplug the power and data cables from the motherboard and/or
backplane.
4 If you are adding a new peripheral drive:.
Remove the mini-bezel (grate) from the drive bay The bezel can be
removed by pulling out the hard drive beneath the drive bay, then
pulling the mini-bezel forward.
If you are replacing a peripheral drive:
Locate the locking tab at the rear (left hand side when viewed from
the front) of the drive. Push the tab toward the drive, and push the
drive unit out the front of the chassis.
5 Push the new drive unit into the slot, until the tab locks into place.
6 Reconnect the data and power cables.
7 Replace the chassis cover, reconnect the power source and power
up the system.
Chapter 4: Chassis Setup and Maintenance
Installing a Peripheral Drive
5
21