Chapter 4: Chassis Setup and Maintenance
Installing Add-on or Expansion Cards
Installing Add-on or Expansion Cards
Figure 9 Installing Add-on or
Expansion Cards
Add-on Card/Expansion
Slot Setup
22
Add-on/Expansion
Card Slots
Remove Screws
The NDX Tower includes a single PCI-e slot. Follow these instructions for
installing a PCI-e card.
1 Disconnect the power supply, set the chassis on a flat surface, and
open the chassis cover.
2 Remove the screws holding the cover in place for each add-on/
expansion card slot you want to use. Keep this screw for later use.
3 Connect the add-on card to the mother board.
4 Secure the card to the chassis using the card's L-bracket and the
screw previously removed.
Quantum NDX NAS Tower User's Guide