Installing The Inner Rails On The Ndx 1U Nas Server; Installing The Outer Rails On The Rack - Quantum NDX Series Installation Manual

NDX NAS 1U Rack Installation Guide
Installing the Inner Rails
on the NDX 1U NAS
Server
Figure 6 Inner Rail Installation
Installing the Outer
Rails on the Rack
8
1 Place one of the inner rails on one side of the NDX 1U NAS server aligning the hooks
on the side of the NDX 1U NAS server with the mounting holes in the rail. Make sure
the inner rail faces outward, as illustrated.
Note: The front inner rail is pre-installed on the NDX 1U NAS server.
2 Slide the inner rail forward so that the rail fits securely into the 4 hooks on the side
of the NDX NAS 1U Rack server.
3 Secure the inner rail to the NDX NAS 1U Rack server with one screw as illustrated in
Figure 6.
4 Repeat steps 1-2 for the remaining inner rail.
1 Attach the shorter outer rail to the outside of the longer outer rail. You must seat
the pin on the rear outer rail with the slide opening in front outer rail. Also, both
bracket ends must face the same direction.
2 Adjust both the shorter and longer brackets to the proper length so that the rail fits
snugly into the rack.
3 Secure the long rail to the front side of the rack with two M5 screws, top and
bottom holes and the short rail to the rear side of the rack with two M5 screws.
4 If the rack does not have threaded holes, install a clip nut or a cage nut in the back
side of the rail and use the cage nut/clip nut screws to secure the unit into the rack
(see Figure 7 below)
5 Repeat steps 1-4 for the remaining outer rail.
Rack Installation