Parker C10 Cable Assembly

Step 6
You are now ready to wire your motor for series or parallel.
Series Wiring
Wire #1
Wire #3
Refer to your product's
Gnd (Grn/Ylw)
user guide for
Wire #2
connection instructions.
Wire #4
The green/yellow (Gnd) wire is for safety
purposes. The shield connection to the motor
case is for EMI purposes (the C10 and C10H cable
kits provides hardware for the shield connection).
Parallel Wiring
Wire #1
Wire #3
Refer to your product's
Gnd (Grn/Ylw)
user guide for
Wire #2
connection instructions.
Wire #4
The green/yellow (Gnd) wire is for safety
purposes. The shield connection to the motor
case is for EMI purposes (the C10 and C10H cable
kits provides hardware for the shield connection).
Step 7
Connect the motor cable to the drive or drive/controller product. Avoid looping
the cable. Keep the motor cable away from I/O cables carrying control signals.
Refer to your product's user guide for instructions.
R-Clamp
Drive End
END OF ASSEMBLY INSTRUCTIONS
page 4
Schematic View End Cover Removed
Phase A
3 4
Windings
1
6
8
6
PM
5
5
2
Phase B 1
3 Windings
2 8 7 4
Motor Terminal Number/Wire Number: Gnd 1 3
Phase A
4
3
Windings
1
6
8
6
PM
5
5
2
Phase B 1
Windings
3
2 8
7 4
Motor Terminal Number/Wire Number: Gnd 1 3
Remove outer jacket only.
Do not cut braid.
To Motor
p/n 88-016411-01 B
C10 & C10H Cable Assembly
At no time during this procedure should the motor cable be allowed to twist within
the gland assembly. This can damage the cable and greatly reduce its life.
7
Step 1
Inventory, what you should have:
• Thread converter
• Gland assembly (5 pieces)
2 4
• Motor cable, 10 ft (3 m)
• R-Clamp with 6-32 x 1/2-inch screw
Required assembly tools and hardware:
• Phillips screwdriver #2
• Wire strippers
• Standard slotted screwdriver, approximately 0.25 in (6 mm)
• Crimp-on ring terminals (C10 cable uses 18AWG, 0.75 mm
7
C10H cable uses 14 AWG, 2.50 mm
9 required for series wiring, 13 required for parallel wiring
• 18AWG (0.75 mm
4 inches (100 mm) long – see step 6:
2 required for series wiring, 4 required for parallel wiring
• Crimp tool
2 4
• Open-end 15/16-inch wrench
R-Clamp and Screw
p/n 88-016411-01 B
CAUTION
2 wire) – see step 6:
2 ) wire jumpers (use 18 AWG for both C10 & C10H),
Exposed Braid
Outter Jacket
Drive End
Motor Cable
(10-foot)
Rubber Moisture Seal
EMI Shield
Top Half of Casing
Gland
(for R & T Series Motors)
2 wire;
Inner Jacket
Motor End
Brass Contact Sleeve
Base Half of Casing
Thread
Converter
page 1