Advertisement

Quick Links

HINT: Always start VMD in a gas free
environment.
IMPORTANT:
Follow
your
calibration requirements.
Attach the GPS antenna to the connection
labeled "GPS" on the bottom of the tablet.
Attach the Bluetooth antenna to the center
connection on the top of the tablet.
Insert the tablet power harness into the bottom
of the tablet and the opposite end into a 12
volt jack on the vehicle.
WARNINGS: For best results, clean the
lenses each day prior to use.
Use extreme caution when monitoring the
computer when driving.
Any adjustments
should be made only when the vehicle is safely
stopped and away from traffic.
When not in use, refer to transport position
recommendation in the user manual to prevent
potential damage.
company's
851 Transport Drive
Valparaiso, IN 46383-8432
Innovative Detection Solutions
Phone: 219 465 2700
Web:
www.gasleaksensors.com
MADE IN THE USA
WITH GLOBALLY SOURCED COMPONENTS
Distributed by:
Quick-Start Instructions
This is not a substitute for the
instruction manual. It is for
reference only.
Read and understand the
instruction manual before use.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VMD and is the answer not in the manual?

Questions and answers

Summary of Contents for SENSIT Technologies VMD

  • Page 1 HINT: Always start VMD in a gas free Quick-Start Instructions environment. IMPORTANT: Follow your company’s 851 Transport Drive Phone: 219 465 2700 calibration requirements. Valparaiso, IN 46383-8432 Web: www.gasleaksensors.com Attach the GPS antenna to the connection Innovative Detection Solutions labeled “GPS” on the bottom of the tablet.
  • Page 2 13. To calibrate, a survey must be stopped 7. To start survey, press “start 1. Install the VMD on the “L” bracket. Be sure survey” (F4). A logging file will be (if active). Press the “calibrate” button. that the pin is secure and the “jam bolt”...

Table of Contents