Introduction
2.3.2 LEDs
There are two light-emitting diodes (LEDs) on the front face of the device:
Power Indicator LED—this device uses three colors to show the batteryand power status as
•
follows:
Hard Drive Activity LED—illuminates when the central processing unit (CPU) is reading or
•
writing to the hard disk drive (HDD).
2.3.3 The Stand
The built-in stand extends from the back of the unit to allow hands-free viewing. The stand clips
into the unit for storage and pivots out so the display is at a 35 degree angle when in use.
2.4 Power Sources
Your Display Device can receive power from any of the following sources:
Internal Battery Pack
•
AC/DC Power Supply
•
Charging Station (Optional)
•
2.4.1 Internal Battery Pack
The display unit can be powered from the internal rechargeable battery. A fully charged standard
battery provides sufficient power for about 3.5 hours of continuous operation. An optional
high-capacity battery that provides 5.5 hours of operation is available. An LED on the front of the
unit indicates the battery state of charge.
2.4.2 AC/DC Power Supply
The unit can be powered from a wall socket using the AC/DC power supply and power cord. The
AC/DC power supply also powers the internal battery pack charging process.
2.4.3 Charging Station (Optional)
–
Green indicates a either a battery with a full, or nearly full, charge or DC power
Orange indicates a battery that is charging. An orange LED that fades on and off at three
–
second intervals indicates the unit is in standby mode.
–
Red indicates a low battery (15% of capacity or less).
7
Power Sources