Setting Up The Wheelchair; Seating System; Seat Height; Centre Of Gravity - Sunrise Medical Quickie Q700-UP M Instructions For Use Manual

4.0 Setting up the wheelchair

The average wheelchair user does not exist. This is why Sunrise
Medical wheelchairs can be adjusted according to specific
needs of the user.
In this, we make a distinction between wheelchair settings and
wheelchair seating adjustment options. Settings are carried
out once, the first time the wheelchair is going to be used.
They must be executed by qualified specialist, unless explicitly
stated otherwise. Seating adjustment options can be carried
out by the user. These adjustment options do not require the
use of tools.

4.1 Seating system

The extensive settings with respect to the seating system allow
for optimum support of the body (& Seating system). The
following setting options are possible:
1. Seat depth and seat width
2. Backrest angle
3. Armrest height/width
4. Lower leg length
5. Angle of the footplate
6. Legrest angle

4.2 Seat height

Depending on the specific circumstances of the user of the
wheelchair the seat height can be set. Every optional seat
height lies within the maximum safe slope as described
in EN12184 (2014) ClassB. Lowering the seat height has a
positive influence on the (dynamic) stability.
WARNING!
Increasing the seat height has a negative effect on dynamic
stability.
Q700-UP M/F Rev.A

4.3 Centre of gravity

DANGER!
Adjusting the centre of gravity on a powered wheelchair is
both physically demanding and safety critical. Sunrise Medical
strongly recommends that this adjustment is only performed
by a service agent/dealer approved by Sunrise Medical.
Adjusting C.O.G. influences stability in a standing position.
Never adjust the centre point of gravity (C.O.G.) on Q700-UP
without consulting a Sunrise Medical professional.

4.4 Controller height and depth

(& Seating system).

4.5 Control system programme

This wheelchair is equipped with a control system that can be
programmed by adjusting settings within the system. This is a
specialized job that needs training and can only be adjusted
with professional software. It's not possible and allowed for
end users to adjust these settings.
DANGER!
The incorrect setting of the parameters for the control system
may result in very dangerous situations.
Settings must be made by qualified specialists.
11