Troubleshooting - Panasonic KX-TGD590C Operating Instructions Manual

Display message
Main unit
no power
or
No link. Re-
connect base
AC adaptor.
Requires
subscription
to Caller ID.
Use
rechargeable
battery.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert them into the handset again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
For assistance, visit www.panasonic.ca/english/support
KX-TG273CSK_(en-en)_0525_ver110.pdf 61
Cause/solution
R Confirm the base unit's AC adaptor is connected to
the unit and the power outlet correctly.
R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 40).
R You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
R A wrong type of battery such as alkaline or
manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 8.
Cause/solution
R Place the handset on the base unit or charger to turn on
the handset.
R Make sure the batteries are installed correctly (page 10).
R Fully charge the batteries (page 11).
R Check the connections (page 10).
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 40).
Useful Information
61
2018/06/02 10:39:11