Safety Grid E37K; Cleaning - Ceado E37J Maintenance Manual

36

SAFETY GRID E37K

Electronic espresso coffee grinder model E37K is equipped with a removable safety grid (20 Fig. 1a).
Before operating the grinder, place the safety grid inside the bean hopper, slotting it into the only position
so that the magnetic sensor (21 Fig. 1a) is in contact with the end of the safety arm (22 Fig. 1a).
Note: Coffee grinder will not start if safety grid is not properly in place.
Any attempt to by-pass the safety device and use the coffee grinder without its safety
grid in place may cause personal injury and/or damage to the appliance.

CLEANING

It is important to keep the appliance clean and in good working order to ensure optimum quality of
the products and long life of the appliance.
Cleaning of the appliance must be carried out by persons with knowledge and practical
experience of the appliance.
At the end of each working day, clean the outer surfaces dirty with coffee (motor housing, tray,
discharge opening etc.). Clean the appliance completely at least once a week.
Always disconnect the plug of the appliance from the power socket before cleaning it.
Clean the motor housing and the tray with a cloth dampened with water or alcohol.
Wipe with a dry cloth.
Never put the appliance under running water and never immerse in water.
Once the hopper has been removed it can be washed with lukewarm water and neutral soap,
then rinse it and dry well.
Use a brush or a paintbrush (Fig. 7) to clean the most hidden areas inside the unit and a dry
cloth for the other surfaces.
GB