Advertisement
FINAL NOTES:
• After the installation is complete, double check that all nuts & bolts are tight. Refer to the following
chart below for the proper torque specifications. (Do not retighten the nuts & bolts where thread
lock compound was used.)
• With the vehicle placed on the ground, cycle the steering lock to lock & inspect the steering,
suspension, brake lines, front & rear drivelines, fuel lines, & wiring harnesses for proper operation,
tightness, & adequate clearance.
• Have the headlights readjusted to the proper settings.
• Have a qualified alignment center realign the front end to the factory specifications.
• Retorque all the bolts after the first 100 miles.
INCh SYSTEM
Bolt Size
Grade 5
5/16
3/8
7/16
1/2
9/16
5/8
135 FT LB
3/4
185 FT LB
• The above specifications are not to be used when the bolt is being installed with a bushing.
Seat Belts Save Lives, Please Wear Your Seat Belt.
I-D6912ST
TORQuE SPECIFICATIONS
Grade 8
15 FT LB
20 FT LB
30 FT LB
35 FT LB
45 FT LB
60 FT LB
65 FT LB
90 FT LB
95 FT LB
130 FTLB
175 FT LB
280 FT LB
METRIC SYSTEM
Bolt Size
6MM
8MM
18 FT LB
10MM
32 FT LB
12 MM
55 FT LB
14MM
85 FT LB
16MM
130 FT LB
18MM
170 FT LB
Class 8.8
Class 10.9
5 FT LB
9 FT LB
23 FT LB
45 FT LB
75 FT LB
120 FT LB
165 FT LB
240 FT LB
Pg 4
Advertisement
