Advertisement
Part #: D6912ST
ITEM#
D6920STS
STSP2
I-D6912ST
Front Installation:
1. Secure & properly block the rear tires of the vehicle on a level
concrete or asphalt surface.
2. Raise the front of the vehicle from the front center cross member &
remove the front tires / wheels. (See Photo # 1)
3. Disconnect the outer tie rod from the steering knuckle. Note: It may be
necessary to strike the side of the knuckle to dislodge the tie rod end.
Be careful not to damage the tie rod end. (See Photo # 2)
4. Disconnect the sway bar end links. (See Photo # 3)
5. Disconnect the upper A-arm ball joint from the top of the steering
knuckle.
6. Disconnect the lower strut mount from the lower A-arm.
7. Remove the three upper strut mounting bolts from the upper frame
mount. (See Photo # 4)
8. Using a strut spring compressor, unload the tension on the upper
mount of the OEM coil assembly. Remove the upper shock retaining
nut & slide the strut out from the bottom. (See Photo # 5)
I-D6912ST
Kit Box Breakdown:
DESCRIPTION
DODGE 1500 STRUT SINGLE
.467 STRUT SPCR RINGS / QTY4
INST SHEET: D6912ST
Photo # 5
QTY
2
1
1
Photo # 1
Photo # 2
Photo # 3
Photo # 4
Pg 2
Advertisement
