GE RAK348T1 Owner's Manual page 11

49-7574 v06 6/7/07 9:44 AM Page 11
Installing or removing receiver (cont.).
A. Press the SW4-INSTALL button
inside the thermostat. Press the
HEAT/COOL button on the front
of the thermostat to select your
choice. Press the UP button to set
the receiver number (0-7) and
press the HEAT/COOL button
to set the receiver.
B. Press the SW9-LINK button
inside the thermostat. Within
5 seconds, press the RESET/LINK
button (PB3) on the receiver. The
"Good" message will appear if
linked. The "Bad" message will
appear if not linked.
C. Press the SW4-INSTALL button
to close the installation session.
Uninstalling a Receiver
Unlike installing a receiver, the procedure to remove will uninstall all receivers installed to the
thermostat at once. You cannot remove a single receiver at a time.
Step One
Press the SW4-INSTALL button inside the thermostat. The "Install" icon will flash. Press the UP
button to get the "Remove" choice and press the HEAT/COOL button to select. The "Heat"
and/or "Cool" icons will be displayed and all display items will be on steady; nothing will be
flashing.
Step Two
Press the SW9-LINK button on the back of the thermostat printed circuit board. Within
5 seconds, activate a Link Service Request on the receiver. When the SW9-LINK button is
pressed, the thermostat will display the "Please Wait" message in the bottom right corner of
the LCD while it searches for a receiver. Once the thermostat finds its installed receiver(s), linking
information is removed from the receivers and the thermostat, the "Please Wait" message is
extinguished and a "Good" message will appear.
Internal Buttons
PB1–NETWORK
Used to uninstall the thermostat
from receiver(s) it has been
SW12-RESET SW4-INSTALL SW9-LINK
linked to.
SW12–RESET
Master Reset – Returns thermostat
to all factory defaults.
SW4–INSTALL
Starts an installation session.
SW12-RESET SW4-INSTALL SW9-LINK
SW9–LINK
Used to link the thermostat to
control receiver(s).
Display
NOTE: The display always blinks
HEAT
COOL
the item that is active and can
be changed.
Install
Node
Good
Please Wait
11