Advertisement
49-7574 v06 6/7/07 9:44 AM Page 10
Installing or removing receiver.
The thermostat and receiver will not operate as a system until they are linked together through
the installation process. The linking process binds one or more receivers to a thermostat so that
they will communicate with each other as a control system. Up to eight (8) receivers can be
linked to a single thermostat. Until linked, a control receiver will not operate. Once linked, a
control receiver will only respond to its specific thermostat.
Link the Thermostat to the Receiver
A thermostat and receiver that have been linked will not interfere with or be affected by any
other thermostat or receiver in adjacent rooms, apartments or neighboring homes. Linking
information is stored in memory—It is not necessary to re-link a thermostat and receiver if the
thermostat batteries are removed or after a power outage.
If multiple installation teams are installing and linking thermostats at the same time, coordinate
the activity to avoid the possibility of installers simultaneously attempting to perform the linking
process. Because this is an RF system, installers in nearby rooms/areas where it is possible RF
overlap could exist run the risk of interfering with each other. Installation and linking activity
going on around a system already installed will not interfere with it.
10
Advertisement
