Maintenance; General; Cleaning-Exterior; Cleaning-Interior - Hatco THERMO-FINISHER TFC-461R Installation And Operating Manual

MAINTENANCE

GENERAL

Hatco Thermo-Finisher conveyor food finishers are
designed for maximum durability and performance
with minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
NOTE: When the unit is HOT the blower fans will
remain on even when the POWER switch is
turned off.
CLEANING - EXTERIOR
To preserve the bright finish of the unit, it is
recommended that the exterior surfaces be wiped
daily with a damp cloth. Stubborn stains may be
removed with a good stainless steel cleaner or a
non-abrasive cleaner.
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your
Thermo-Finisher, marring its appearance and
making it susceptible to dirt accumulation.
CLEANING - INTERIOR
It is recommended that the interior and conveyor
belt system be wiped daily using a damp cloth.
Stubborn stains can be removed using a small brush
and mild soap.
Glass Surfaces
WARNING
To avoid any injury, move the POWER switch to
OFF, unplug the unit from the power source, and
allow to cool before
maintenance.
after the unit has cooled for at least one hour.
Upper and lower glass surfaces can be cleaned
1. Remove the heat retention doors from the unit.
2. Lift the idler shaft from the brackets and allow
shaft to drop down.
3. Lift the conveyor belt up.
4. Carefully scrape loose and wipe off any food
debris that has accumulated on the glass.
CAUTION
Do not remove the glass from the unit for
cleaning purposes. Doing so may cause injury
or damage to the unit.
performing any
12
5. Remove any stains from the heating surfaces by
wiping off the glass using a moist cloth and
ceramic cooktop cleaner.
6. Reposition the idler shaft into the brackets and
reinstall the heat retention doors.
NOTE: The conveyor belt does not require any
lubrication.
WARNING
Unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water. Do not steam clean the interior or flood
with water or liquid solution.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
WARNING
This product has no "user-serviceable" parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Replacement Parts when service
is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Genuine Hatco Replacement
repairing Hatco equipment. Failure to use
Genuine Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or
burn.
do not have the
Parts when
Form No. TFC461RM-0108