Operation; Basic Food Finishing - Hatco THERMO-FINISHER TFC-461R Installation And Operating Manual

OPERATION

BASIC FOOD FINISHING

WARNING
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
CAUTION
DO NOT use "Pyrex" glass plates or serving
pieces in the food finisher. "Pyrex" glass may
break causing personal injury and/or food
contamination.
CAUTION
DO NOT use paper or plastic serving pieces in
the food finisher. These materials may melt or
burn causing a fire hazard and/or food
contamination and may damage the unit.
CAUTION
To avoid any injury or damage to the unit do not
operate appliance
supplied legs.
NOTE: See RECOMMENDED FOOD FINISHING
GUIDE for specific information.
1. Plug unit into an electrical outlet of the correct
voltage, size, and plug configuration. See
SPECIFICATIONS for details.
2. Move the POWER Switch to the ON position
(see Figure 7). The unit will make an audible
beep, automatically go into "Preheat", and the
display will indicate
"OFF", press one of the 10 product selection
keys to put the unit into "Preheat" mode.
3. When the unit is ready for product, the display
will read . Place food pan/plate with food
product on the center.
4. Heat retention doors are located above the
conveyor on the entrance and exit sides and are
adjustable to five height positions. Adjust doors
to allow for proper food product clearance. Doors
should be adjusted to the lowest position
possible to retain heat (see Figure 8).
without installation
. If the display reads
Down
Arrow
Key
Upper
Heat
Indicator
Lower
Heat
Indicator
Up
Arrow
Key
Program
Indicator
Lamps
of
Figure 7. Control Panel
Figure 8. Adjusting Doors
10
Adjustment Screws
Heat Retention Door
Form No. TFC461RM-0108
Digital
Display
Enter
Key
Program
Selection
Keys
(1–10)
POWER
ON/OFF
Switch