All Units; Keys 1-8 - Hatco THERMO-FINISHER TFC-461R Installation And Operating Manual

ALL UNITS

1. Plug unit into an electrical outlet of the correct voltage,
size and plug configuration (see SPECIFICATIONS for
details).
2. Move POWER switch to ON position. The unit will make
an audible beep, automatically go into preheat, and the
display will indicate
3. After one minute and ten seconds, the preheat cycle is
complete, the display reads
programmed.
4. Proceed to keys 1–8 or keys 9 and 10.
KEYS 1 – 8 (CYCLE ONCE WHEN PRESSED)
1. With display showing
the desired program
Enter key for five seconds.
2. After 3 seconds, the upper heat indicator glows and the unit
displays (Upper Power Value).
3. Repeatedly press the Up
to desired setting.
4. Press the Enter
5. The display shows
Repeatedly press Up
desired setting. Holding down an arrow key will cause the
numbers to change rapidly.
Time can be adjusted from zero to 9 minutes 59 seconds.
6. Press the Enter
7. The lower heat indicator glows and the display reads
(Lower Power Value).
8. Repeatedly press Up
desired setting.
9. Press the Enter
10.The display shows
press Up or Down
setting. Values change by 1 second every time an arrow
key is pressed. Holding down an arrow key will cause the
numbers to change rapidly.
Time can be adjusted from zero to 9 minutes 59 seconds.
11. Press the Enter
12.Press the program selection key selected in Step 1 to save
all the settings into memory. The display will show
13.Repeat steps 1–12 to program the remaining program
selection keys 1–8.
Form No. TFC461RM-0108
..
and is ready to be
, simultaneously press/hold
selection key
or Down arrow key to scroll
key to proceed to the next step.
(Upper Time Value).
or Down arrow key to scroll to
key to proceed to the next step.
or Down arrow key to scroll to
key to proceed to the next step.
(Lower Time Value). Repeatedly
arrow key to scroll to desired
key to proceed to the next step.
PROGRAMMING THE UNIT
(1–8) and
.
7