Linking Devices - zappi -32A1P1T05 Operation & Installation Manual

Configuration

Linking Devices

Up to six myenergi devices can be wirelessly linked to together. By linking more devices, you can use more of your own energy
or have more control and visibility. Devices available now or soon to be available are:
zappi – An eco-smart electric vehicle charge point that can use surplus power to charge the car.
harvi – A self-powered wireless sensor that can be used along with
and eddi and is able to report the grid or generation power information to the other devices wirelessly, this can greatly
simplify installation.
hub – The link between your
Adding Devices
Adding a device is simple, it involves putting one device in Pairing Mode and selecting Add Device on another unit.
1.
Navigate to the Linked
Settings, then Advanced and then Linked Devices
2.
The device you want to add needs to be in Pairing Mode. This is
done by either pressing the pair button or by selecting Pair
Mode on the screen (depending on the actual device)
3.
On the already installed load controlling device such as the
zappi or eddi , select Add Device in the Linked Devices menu which is found the Advanced Settings menu
4.
You will now see the ADD DEVICE screen and
channel and are in Pairing Mode. Any devices found are listed
along with their unique serial numbers
5.
Select the device you want to add by highlighting the
appropriate device using the
pressing The device will then be added and the screen will
return to the previous menu
Channels
On rare occasions it is possible that there are other appliances operating on the same frequency which could cause
interference. If it is not possible to link devices or the connection seems poor, changing the RF Channel may help. To do this
make sure all devices are removed from the network by selecting Reset Settings in the Linked Devices menu and
then select a different channel with the Channel menu option. Be sure to change the channel on the other devices before
attempting to link them.
Removing Devices
A device can be removed by selecting it from the Devices menu and then selecting Remove Device
Device Settings
Most device types have settings which can only be changed via the Linked Devices menu. For example,
have a settings for priority and
The device settings are accessed through the Linked Devices menu; select Devices then select the appropriate device
and press to bring up the devices' settings screen. Refer to the relevant devices' instruction document for more information
regarding the actual device settings.
zappi
20
myenergi devices and the internet, allowing remote monitoring and control.
Devices menu by selecting
and buttons and then
harvi has settings to configure its CT inputs (see Device Priorities page 21).
myenergi load controlling devices such as
zappi will be searching for other devices which are on the same
operation and installation manual
zappi
.
zappi and eddi