Advertisement
Hardware
Top
Bracket
¼-20 x 0.5"
Flange
Screw
T49
T50- Kickstand bracket
and hardware bag
T49- Kickstand
Stand Assembly
Kickstand Position
Step 11
©2014 Schiller Grounds Care, Inc.
P/N 430094 , Rev A
QUICK ASSEMBLY SHEET
Kickstand Assembly for Models 7924, 7925, 7940
Top Bracket
T50
Step 8
Lean the Tiller Handles against a sturdy
surface, so the tiller is supported in the
upright position. Place the Top Bracket
over the Lower Handles and below the
Carry Handle.
Place the Kickstand in the
folded position. The
Kickstand should be centered
between the Lower Handles.
If not, loosen the screws
slightly, adjust as necessary
and retighten the screws.
IMPORTANT NOTE:
Read the Safety Rules &
Warnings before you
use your Mantis tiller
Tools Needed: 3/8" wrench.
Bottom Bracket
Step 9
Place the Bottom Bracket of
the Kickstand Stand
Assembly T49 under the
Lower Handles and line up
the holes in both brackets.
Models
7920,7921
Tighten Hardware
Step 10
Insert two screws through the
holes in the Top Bracket and into
the threaded inserts of the Lower
Bracket. Tighten with the 3/8"
wrench.
Models
Model
7924,7925
7940
Advertisement
