Leckey Horizon User Manual page 17

Hide thumbs Also See for Horizon:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
10.6 The Front Knee
Supports
The knee brackets come as standard
with knee supports; these should always
be used when the user is in supine but
can also be used for prone standing
for additional support and security. To
fasten the pad insert the plastic clip into
the buckle on the side of the main knee
support. Then grab the straps ends and pull
firmly away from the user, which will secure
the pad around the users leg. To remove
the pad simply squeeze the tabs on the top
and bottom of the plastic clip and the pad
will pop off (c).
Always check with your therapist as to
the correct tensioning of the straps for
your child as the kneecap is a sensitive
area and too much force could
cause injury.
C
10.7 Activity Tray
Adjustment – Supine
The Tray is attached to and removed from
the frame by the metal brackets located
below the chest pad. To attach the tray
slide the metal bars into the receiving
tubes to the required depth and secure
by tightening the knobs (a) on rather side.
There are limit poppers in the end of the
tray tubes to show the maximum depth
adjustment allowed. These may need to be
depressed to
remove the tray.
To adjust the height loosen the four knobs
(b), set the tray to the required position and
then retighten the knobs securely.
B
The tray angle can be adjusted by
loosening the plastic handle (c) on either
side of the tray, set the tray to the required
angle and tighten the plastic handles again
securely.
A
B
10.8 Activity Tray
Adjustment – Prone
To lock the tray and set its height push the
locking lever (a) down until it touches the
metal spine. After use this may need to
be fine tuned to ensure secure locking. To
do this lift up the lever and turn the nut (b)
while holding the lever in a fixed position.
Push the lever back down to check if it
locks the tube securely. Repeat the process
as necessary.
The tray angle can be adjusted by
loosening the ratchet handle on either side
of the tray, set the tray to the required
angle and tighten the plastic handles
again securely.
B
C
A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents