Advertisement
IMPORTANT: DRILL THE 6 HOLES BEFORE MAKING
THE CUTOUT.
Accurately drill the three holes on each side of the cut-
out area with a 3/16 inch drill.
With the saw on the INSIDE OF THE PENCIL LINES
carefully cut out the rectangular opening.
Secure the mounting strips to the rear of the cabinet
panel using two screws from the hardware package.
Insert the screws in the center holes of cabinet panel
("B" holes on the template) and tighten. The screw head
should pull into the wood slightly. (Use two ¾ inch long
screws for panels under ½ inch, or two 1¼ inch long
screws for panels ½ inch thick and larger.)
Attach the mounting brackets to the cabinet panel using
four screws.
Place the template over the mounting screws. The
mounting screws should be centered in the "A" and "B"
holes on the template. The sides of the mounting brackets
should match the vertical dash lines on the template. If
necessary, loosen the screws and push the brackets into
alignment and retighten.
Insert the power cord through the opening. Carefully
slide the MX 113 into the opening so the rails on the bot-
tom of the equipment slide in the track of the mounting
brackets. Slide the instrument in until it stops at the adjust
position latches. Press the latches in and continue to slide
the instrument in until the front panel is against the
cabinet panel. At the bottom corners of the front panel are
the PANLOC buttons. Depressing the PANLOC buttons
will lock the instrument firmly in the installation. Depress-
ing the PANLOC buttons a second time will release the
instrument. You can then slide the instrument forward to
the inspection-adjustment position. Depressing the inspec-
tion-adjustment position latches will allow the instrument
to slide completely out of the installation.
Advertisement
