Worx Landroid L WG792E Programming Manual

Programming guide
Control Panel and menu
HOMEPAGE
Display the state of your setting
HOME
Sends the Landroid L to its
®
charging base during operation
POWER ON/OFF
turns the Landroid ® L
ON and OFF
Menu overview
Programming
After you have successfully installed the Landroid
Start
To quick start your Landroid L, first Open the keypad window by pressing the large red button
®
start and close the keypad window. Press
The Landroid ® L will work continuously until it is out of battery and then it will return to the charging base. Once charging is complete, the Landroid
mowing or if it has finished mowing it will stay in the charging base.
The factory default setting is 1500m (refer to the Auto Mowing Time Schedule), if the time is not in the schedule, press
2
If you want to change the working time and other settings, please follow the steps below:
Setting
Press OK to enter the submenu.
Use the keys to select General setting, Working time or Security. Then press OK.
1. General setting (
HOMEPAGE
L, it is now ready to be programmed according to your schedule. To program your Landroid
®
and close the keypad window , this will send Landroid
)
STOP
Opens the protective screen to
access the keyboard.
To stop the Landroid ® L during
normal operation and charging.
Select up
Select down
RETURN
Back to proceeding menu
OK
Confirms any setting.
Note: Make sure you confirm your
selection within 30 secs or the
display will return to previous menu.
START
Shortcut key to start mowing.
General Setting
Working Time
Security
, then Press ON/OFF button
® L back to the charging station and mow the lawn near the boundary wire.
to start and close the keypad window.
Always close the keypad window
after programming.
Your Landroid L will not move
®
with it open.
Language
Time Format
Date Format
Set Date & Time
Rain Start Delay
Auto Work Time
Customize Work Time
Customize Work Area
Enable Boundary Cut
Change PIN Code
Alarm Level
L, simply follow the step by step guide below.
®
, input the default PIN 0000, and Press
® L will automatically resume
to