Inverter MINI SPLIT Owner's Manual And Installation Manual page 35

Installation of indoor unit
2. Make the power connection wire go
through the cable-cross hole at the back
the front side.
with wire clip.
Wiring Cover
4. Put wiring cover back and then tighten the screw.
5. Close the panel.
Notice before installation
1. How to install the over line pipe
(According to the direction as show.)
wire pipe
Note:
All wires of indoor unit and outdoor unit should be connected by a professional.
for a new one. Avoid extending the wire by yourself.
installation.
The circuit break should be all-pole parting and the contact parting distance
09、12K: (230V),(115V)
18K 24K: (230V)
N(1)
N(1)
Screw
1/8in( )
cable-cross
hole
power connection
wire
N(1) 2 3
GND
blue black brown yellow-green
N(1) 2 3 L N
Outdoor unit connection
2 3
GND
2 3
L1 L2 G
GND
Outdoor unit connection
2. Finish (According to the
direction as show in right figure.)
32
GND GND