Typical Installation - Whirlpool WHES Series Installation Instructions Manual

THE PROPER ORDER TO INSTALL WATER TREATMENT EQUIPMENT
Untreated Water to
Cold Water
to House
Hot Water
to House
Water
Heater
Hard Water
To Outside
Faucets
Water Softener
Valve
To
Controller
Plug-in
Power
Supply
Valve Drain
Elbow
Valve Drain
Hose*
*Do not connect the
water softener valve drain
tubing to the salt storage
tank overflow hose.
Questions? Call Toll Free 1-866-986-3223
When you call, please be prepared to provide the model and serial number,
found on the rating decal, typically located on the rim below the salt lid hinges.
Outside Faucets
Optional
Sediment
Filter
Water
Softener

TYPICAL INSTALLATION

Overflow
Drain Elbow
Salt Storage
Tank Overflow
Hose*
Floor Drain
or visit www.whirlpoolwatersofteners.com
City Water Supply
Pressure
Tank
Well Water Supply
Pump
Conditioned
Water
Clips
Inlet
Lubricated
O-ring
Secure Valve Drain Hose
in place over Floor Drain
NOTE: See "Air Gap Requirements" section.
NOTE: Water Softener shown with Salt Lid and
1-1/2"
air gap
Monday- Friday, 8 AM - 7 PM EST
4
OR
Well
Pipe
1" NPT Sweat
Adaptor (not
included)
1" NPT
Threaded
Adaptor
Outlet
O-ring
Single
Bypass Valve
Top Cover removed
FIG. 6
FIG. 7