Related Manuals for pro bel V6271
Summary of Contents for pro bel V6271
- Page 1 V6271 Video Monitoring Distribution Amplifier and DAC User Guide Issue: 1.0 © Pro-Bel Ltd www.pro-bel.com...
-
Page 2: Table Of Contents
VISTEK V6271 Video Monitoring DA & DAC Contents Description Installation Rear Panel Connections Interfacing Insertion Delay Hardware Front Panel 2.5.1 Panel Indicators 2.5.2 Control Switches Initialisation Operation Default Rate 625 Standard 525 Standard NTSC Standard Vertical Blanking Ancillary Blanking Horizontal Blanking Outputs A &... -
Page 3: Description
& DAC Description The V6271 is a Serial Digital Video Distribution Amplifier with converters to analague composite and component signals, which forms part of the Vistek V1600 range of interface products. It is a 3U high card, which is fitted into either a V1601, V1603 or V1606 rack, from which it gets its power and remote control. -
Page 4: Installation
VISTEK V6271 Video Monitoring DA & DAC Installation Rear Panel Connections The V6271 rear module connections are shown below. 3U Rear Module (16VR3B) 1U Rear Module (16VR1B) SDI 1 SDI 2 CVBS/Pr/R CVBS/Y/G CVBS/Y SDI 2 SDI 3 DART SDI 4... -
Page 5: Hardware
VISTEK V6271 Video Monitoring DA & DAC Hardware The figure below shows diagrammatically the printed circuit board along with certain other components of interest. In particular it shows the position and orientation of the controls and switches, which set up Outputs when operated in Local control... -
Page 6: Front Panel
VISTEK V6271 Video Monitoring DA & DAC Front Panel Remote Control Access and Power indicators PAL I PAL N Input Signal Format NTSC PAL M YUV/ Analogue Output Type (CVBS or YC, YUV/GBR) (amber) Test Signal Local Selection & Global Indication of Test Pattern... -
Page 7: Panel Indicators
VISTEK V6271 Video Monitoring DA & DAC 2.5.1 Panel Indicators The LEDs on the panel have these meanings Short blinks to indicate access by the DART controller, if fitted. It does not indicate that the unit is in one of its remote control modes. -
Page 8: Operation
VISTEK V6271 Video Monitoring DA & DAC Operation Default Rate This selection determines the default line rate when no input is present. If there is an input the module outputs will switch to the input line rate and standard defined below. -
Page 9: Outputs A & B
VISTEK V6271 Video Monitoring DA & DAC Outputs A & B The outputs A & B can be selcted to be either composite video or YC components Test Pattern The internal Test pattern can be selected between Pluge (for monitor alignment) and Colour Bars. -
Page 10: Feature 3
VISTEK V6271 Video Monitoring DA & DAC 3.16 Feature 3 Reserved. HU-V6271... -
Page 11: Dac Calibration
Y, Pb, Pr, G, B, R outputs. When in calibration mode the outputs are automatically selected to CVBS and Y, Pb, Pr and only the CVBS/Y (or the CVBS/C on a V6271/4) and Y/G outputs need to be monitored for adjustment.
Need help?
Do you have a question about the V6271 and is the answer not in the manual?
Questions and answers