VISTEK V6151 & V6152 hd/sd distribution amplifiers DESCRIPTION The V6151 and V6152 are serial digital video Distribution Amplifiers for use with both High Definition and Standard Definition SDI signals. The V6151 has a single input and five outputs, while the V6152 has one input and ten outputs.
Page 4
VISTEK V6151 & V6152 hd/sd distribution amplifiers INSTALLATION Rear Panel Connections The V1651 and V6152 units can only be used in a 3U chassis , but use different width rear modules. The V16HR3A and 1V6HR3B are shown below: SIGNAL SOURCE...
Page 5
VISTEK V6151 & V6152 hd/sd distribution amplifiers Front Panels These are the two front panels. Only the re-clocking DA, the V6151, has an indication that the input signal is present. INDICATORS DESCRIPTION Onboard regulated power is present. Short blips to indicate access from the remote control system. A Rack Controller must be fitted to the Chassis.
Page 6
VISTEK V6151 & V6152 hd/sd distribution amplifiers Insertion Delay SD (270Mb/s) HD (1.485Gb/s) UNIT O/Ps 1-5 O/Ps 6-10 O/Ps 1-5 O/Ps 6-10 V6151 11ns V6152 11ns 11.5ns 8.5ns The insertion delay is specified with the rer-clocker enabled. Hardware The figure below shows diagrammatically the main board of both DAs along with some components of interest.
Need help?
Do you have a question about the Vistek V6151 and is the answer not in the manual?
Questions and answers