Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for pro bel VISTEK V6301
Summary of Contents for pro bel VISTEK V6301
- Page 1 VISTEK V6301 AUDIO WORDCLOCK DISTRIBUTION AMPLIFIER USER GUIDE www.pro-bel.com...
-
Page 2: Table Of Contents
VISTEK V6301 audio wordclock distribution amplifier Contents DESCRIPTION......................3 INSTALLATION ......................4 2.1 Rear Panel Connections...................4 Table 2.1.1......................5 2.2 Input Impedance Selection ................5 2.3 DA Mode ......................6 OPERATION .......................7 3.1 Front Panel ......................7 3.2 LED Indications....................7 3.3 Mode Controls....................8 3.4 DART Interface ....................8... -
Page 3: Description
VISTEK V6301 audio wordclock distribution amplifier DESCRIPTION The V6301 is a broadcast quality distribution amplifier which form part of the Vistek V1600 range of interface products. It is a 3U high card which is fitted into either a V1601 or V1603 rack, from which it receives its power. -
Page 4: Installation
VISTEK V6301 audio wordclock distribution amplifier INSTALLATION Rear Panel Connections The 3U BNC and 3U Screw terminal rear panels are shown below. Note: All inputs and outputs must be connected with coaxial cable. The inputs/outputs are connected with 'hot' to the '+' terminal (centre on BNC's) and the ground to the 'S' terminal (outer GND on BNC's). -
Page 5: Input Impedance Selection
VISTEK V6301 audio wordclock distribution amplifier Table 2.1.1 Description of V6301 rear panel connections for standard rear panels SIGNAL SOURCE COMMENTS POWER Rack PWR Header +15V at 100mA (1.5W max) DART bus Rack DART header Vistek DART Rack controller W/CLK A(IN) W/CLK ext. -
Page 6: Da Mode
VISTEK V6301 audio wordclock distribution amplifier DA Mode The V6301 DA has 4 modes op operation, controlled by DART or front panel switches. When the LOCAL switch is set to , control is by panel switches. Four possible modes, namely two 2:4 modes and two 1:8... -
Page 7: Operation
VISTEK V6301 audio wordclock distribution amplifier OPERATION Front Panel Remote Control Access and Power indicators ERROR ERROR indicators A out MODE controls B out Local V6301 Audio W/CLK DA LED Indications The V6301 has front panel indicators as shown above. -
Page 8: Mode Controls
VISTEK V6301 audio wordclock distribution amplifier Mode Controls The V6301 has two input channels Ain and Bin and two groups of four output channels Aout and Bout. The mode controls Aout and Bout allow each of the two groups of four output channels to receive signal from either the Ain or Bin inputs.
Need help?
Do you have a question about the VISTEK V6301 and is the answer not in the manual?
Questions and answers