Battery Charging; Power-On And -Off - Industrial Scientific Ventis MX4 Product Manual

Ventis™ MX4 Product Manual
Part Number
18108653
NOTE: The above products are all equipped with a yellow LED "presence" indicator. This LED confirms that the monitor is properly seated in the
cradle such that the monitor can charge; however, it is NOT intended to be used as a charging indicator. This LED indicator may go out intermittently
during normal charging functions and will not light if the unit is fully charged when placed in the cradle. Always refer to the monitor display's battery
level indicator to confirm the battery charge level.

Battery Charging

Charger insert placement
If the charger includes an insert, adjust the insert's position to ensure the battery contacts touch the charging
contacts.
Lithium-ion battery
Insert side 1: forward
position
NOTE: Do NOT touch the battery contacts located at the front of the charger as contaminants and damage will inhibit the
battery's ability to charge.

Power-on and -off

To power-on the Ventis MX4, press ON/OFF/MODE and hold for three to five seconds. During the first ten to15
seconds the monitor is on, its firmware completes internal tests and the user sees or hears what is described and
shown below. Following this initialization phase, a countdown screen displays. During this 20-second countdown, the
monitor user can enter configuration mode to manually adjust monitor settings.
© 2018 Industrial Scientific Corporation
Product
Ventis Single Unit Truck-Mount Charger, 12 VDC, Hard Wired
Slim extended lithium-ion
battery
Insert side 2: forward
position
Extended range lithium-
ion battery
Insert side 1: Rear
position
Rear insert position
Forward insert position
—
Once the insert is placed
into the desired position, a
firm push down will secure
it in place.
To prevent losing the
insert, keep it in the cradle
in the most often used
position.
16