Page 1
Warnin Installati ion of DEMA p products must meet all applic cable electrical l codes and reg gulations establ lished by nation nal, city, count...
Packing List X = included in kit Part Number Description 904.8T RINSE CHECK VALVE ¼” OD TEFLON BALL 80.55 LIQUID DETERGENT FEED INJECTION ELBOW 81.312.1 SPLIT PICK UP TUBE STIFFENER 25.68.20 20 FT ¼” OD LDPE TUBING C.12B CONDUCTIVITY CELL 100.12.SV1 VINYL RINSE TUBING 58.5...
NITRO/NITRO EXPRESS DETERGENT MOTOR ONLY REPLACEMENT KIT 81.316.6 NITRO/NITRO EXPRESS DETERGENT VALVE CONVERSION AND REPLACEMENT KIT 81.316.5 NITRO/NITRO EXPRESS RINSE PUMP HEAD AND MOTOR REPLACEMENT KIT 81.316.11 NITRO/NITRO EXPRESS RINSE MOTOR ONLY REPLACEMENT KIT 81.316.8 NITRO/NITRO EXPRESS DETERGENT PUMP HEAD ONLY REPLACEMENT KIT 81.316.9...
Page 4
Nitro Expre ess will be oper rating in the co oncentration mo ode, locate the proper position n for the DEMA A C- B probe in the w wash tank. The e probe must be e installed below w the water lev vel, normally 1 -2”...
The following steps will help to insure the proper wiring of the unit. The unit should be triggered to power on from the dish machine that it is being used in conjunction with. DEMA Engineering does not recommend powering the unit separately from the dish machine.
Dip Switches The following diagram illustrates what the different switches refer to so that the Nitro Express can be set up for the proper situation. The dip switches are set up so that the “up” position is “on” and the “down” position is “off”.
Page 7
The settings for the probe configuration are the same when the dispenser is being used in door or conveyor mode. Detergent Concentration Level – The detergent knob sets the DETERGENT concentration level or set point. DEMA Engineering recommends Concentration starting in normal range (set using switch 3) and using a titration kit to Normal Range achieve the desired detergent concentration level.
Rubber and synthetic rubber parts such as “o”-rings, diaphragms, PVC tubing, and gaskets are considered expendable and are not covered under warranty. This warranty is extended only to the original buyer of DEMA products. If products are altered or repaired without prior approval of DEMA, this warranty is void.
Need help?
Do you have a question about the Nitro Express and is the answer not in the manual?
Questions and answers