Safety Requirements - Sears Craftsman 944.525410 Owner's Manual

GAS O LINE
FILLER CAP
MUF FLER
CHOKE
CON TROL
PRIM ER
SAFETY
IGNITION
KEY
THROTTLE
CLEAN-OUT
TOOL
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil starter handle - used for start ing en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
Throttle- used to se lect FAST or SLOW engine speeds.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
OPERATION
ELECTRIC
START
BUTTON
RECOIL
STARTER
HANDLE
ON / OFF
SWITCH
CHUTE
DE FLEC TOR
DISCHARGE
CHUTE
FIG. 8
9
DISCHARGE CHUTE CONTROL LEVER
AUGER
CONTROL
LEVER
LIGHT
SKID PLATE
LH and RH turn triggers - used to steer the snow thrower.
Traction drive control lever - used to engage power-
pro pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di rec-
tion the snow is thrown.
Defl ector remote control lever - used to change the
dis tance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
DRIVE SPEED
CON TROL LEVER
DEFLECTOR
REMOTE
CONTROL
LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
HANDLE KNOB
MUF FLER