Bosch 1 270 020 900 Original Instructions Manual page 39

OBJ_BUCH-1407-001.book Page 39 Monday, January 17, 2011 2:58 PM
Charging Procedure
The charging procedure begins as soon as the
charger is connected with the battery and the
mains supply.
Note: The charging procedure is only possible
when the temperature of the battery is within
the allowable charge-temperature range.
You can select between the two charging modes
"FAST" (rapid-charging operation) and "SLOW"
(silent-charging operation). In the "SLOW"
mode, the charging takes place silently.
Charge Operation "FAST"
Charging current 4 A
Operation indi-
cator 28 flashes
Charger ventilation on
When starting the operation of the charger, rap-
id-charging operation is preset. To change the
charging mode, press button 27.
Use caution when touching the charger dur-
ing the charging procedure. Wear protec-
tive gloves. Especially in FAST charging
mode with high ambient temperatures, the
charger can heat up considerably.
Note: Pay attention that the charger is well ven-
tilated during the charging procedure and that
the ventilation openings 22 on both sides are
not clogged or contaminated.
During the charging procedure, the LEDs of
charge-control indicator 13 on the battery light
up. Each continuously lit LED is equivalent to a
charge capacity of approx. 20 %. The flashing
LED indicates the charging of the next 20 %.
The battery is completely charged when all five
LEDs of indicator 13 light up continuously. The
charge procedure is automatically ended.
Disconnect the charger from the mains supply
and the battery from the charger.
When disconnecting the battery from the charg-
er, the battery is automatically switched off.
The battery can now be inserted into the eBike.
Bosch ebike Systems
Troubleshooting
Corrective Measures
Cause
Operation indicator 28 not lit, no charging
possible
Incorrect mains
voltage selected at
switch 24
Plug not inserted
correctly
"SLOW"
Contacts of the bat-
1 A
tery contaminated
continu-
Battery too warm or
ously lit
too cold
off
Ventilation open-
ings 22 of the charg-
er clogged or con-
taminated
Socket outlet, cable
or charger defective
Battery defective
English | 39
Causes and
–
Corrective Measure
Select correct mains
voltage
Check all plug connec-
tions
Carefully clean the con-
tacts of the battery
Allow battery to adjust
to the ambient temper-
ature until the charge-
temperature range is
reached
Clean ventilation open-
ings 22 and set up
charger well ventilated
Check mains voltage,
have charger checked
through bicycle dealer
Replace battery
0 276 001 XXX | (17.1.11)