Advertisement
ROLLER SHADES – SPRING LOAD TYPE
PIN END
RIGHT SIDE
SPRING END
ALUMINUM ROLLER OR TUBE
LEFT SIDE
Spring Bracket
Pin Bracket
Spring end (flat pin) always goes to the left side and the round or pin end to the right side.
Brackets to be installed accordingly.
For reverse roll the opposite applies. All pin end brackets are supplied with a plastic bushing to ensure smooth quiet
operation.
To Install Brackets: Ensure brackets are level. To calculate the spacing between the brackets add 7/8" to the width of
the shade fabric, for shades up to 78 1/4" in width. For shades over 78 1/4" Add 1" to the width of the shade fabric.
This spacing measurement should be taken from outside of brackets. If wall plugs are required use a #6 plastic plug.
Always raise or lower the shade gripping the middle of the shade. Pulling on one side will cause the material to roll up
on an angle.
Shades should always be ordered 12" longer that the actual window opening. This allows the shade to be drawn full
length without danger of being torn from the roller.
Guarantee
Advertisement
