Safety Precautions; System Characteristics - golmar RD-V2PLUS Instruction Manual

3
Install or modify the equipment
O
The installation and handling of these equipments must be performed by
O
The entire installation must be at least
O
Do not use excessive force when tightening the connector screws.
O
Install the unit in a dry and protected place without risk of drip or water projections.
O
Avoid to place it near to heating sources, dusty locations, humid or smoky enviroments.
O
Do not block ventilation holes of the unit so that air can circulate freely.
O
To avoid damage, the repeater has to be firmly fixed.
O
Digital repeater for
O
It increases the distance in 200 meters more.
w
In daisy chain installations (without distributors), it increases 16 monitors/telephones in a maximum
w
distance of 150 meters between the repeater and the last monitor/telephone and between
monitors/telephones of the different apartments (connected to repeater).
It increases 32 monitors/telephones in a maximum distance of 150 meters between the repeater
w
and the last monitor/telephone and between monitors/telephones of the different apartments
(connected to repeater).
In installations with 2 repeaters in daisy chain and 1 multiplexer the distances will be:
O
The repeater will increase the distance in 150 meters more.
w
In daisy chain installations (without distributors), it increases 16 monitors/telephones in a maximum
w
distance of 100 meters between the repeater and the last monitor/telephone and between
monitors/telephones of the different apartments (connected to repeater).
It increases 32 monitors/telephones in a maximum distance of 100 meters between the repeater
w
and the last monitor/telephone and between monitors/telephones of the different apartments
(connected to repeater).
Up to 2 digital repeaters connected in daisy chain.
O
Maximum distance between the power supply and digital repeater: 3 m., with a wire section of 1,5 mm.
O
Autodiagnostic leds showing the Bus status (in the riser where repeater is installed) and the power
O
supply status of the repeater.
The
Tekna V2Plus Color
O
repeater.
IMPORTANT: In the output of a
O
Use Golmar
RAP-2150
O
without the power connected
40 cm.
system a llows one of these functions at once
V2Plus
monitor must be the version
distributor cannot be connected another distributor
cable in the
V2Plus system

SAFETY PRECAUTIONS

.
away from any
other installation

SYSTEM CHARACTERISTICS

or later, for its compatibility with the
V.02
.
authorised personnel
.
:
.
.
2