Enable Or Disable Scrolling And Tapping - Sony Vaio VGP-BRMP10 Operating Instructions Manual

Enable or disable scrolling and tapping

You can enable or disable the touchpad's scrolling and tapping features
(page 00). The scrolling and tapping features are enabled at the factory.
1
Turn on the power switch (shown in rectangle) while
simultaneously pressing and holding the SLIDE SHOW
button, Left button, and Next Slide button (shown in circle).
2
The POWER lamp flashes green and yellow.
Perform the following operation while it is flashing.
Note
If you do not perform the above operation within 10 seconds, the power turns on
with the settings unchanged. Press the SLIDE SHOW button to skip setup and turn
on the power.
3
Enable or disable scrolling and tapping.
To enable scrolling
Press and hold the Next Slide button for over 1 second.
To disable scrolling
Press and hold the Previous Slide button for over 1 second.
To enable tapping
Press and hold the Right button for over 1 second.
To disable tapping
Press and hold the Left button for over 1 second.
The controller turns on with the new settings.
Note
You cannot enable/disable the scrolling and tapping features at the same time. To set
each of these features, follow steps 1 to 3 to set the scrolling or tapping feature, then
turn off the power and perform steps 1 to 3 again.
z Hint
The setting you performed in step 3 will be saved until you set it again, even if you
remove the batteries or turn the power off and on.
GB
14
VGP-BRMP10_3-196-908-01(1)