Pentair Fleck 2510 Service Manual page 7

MODEL 3200 TIMER
regeneration cycle program setting procedure
(rapid rinse) White drive cam and brine valve cam
How To Set The Regeneration Cycle Program:
The regeneration cycle program on your water
conditioner has been factory preset, however, portions
of the cycle or program may be lengthened or shortened
in time to suit local conditions.
The expose cycle program wheel, grasp timer in upper
left-hand corner an pull, releasing snap retainer and
swinging timer to the right.
To change the regeneration cycle program, the program
wheel must be removed. Grasp program wheel and
squeeze protruding lugs towards center, lift program
wheel off timer. (Switch arms may require movement to
facilitate removal.)
How To Change The Length Of The Backwash Time:
The program wheel as shown in the drawing is in the
service position. As you look at the numbered side of
the program wheel, the group of pins starting at zero
determines the length of time your unit will backwash.
FOR EXAMPLE: If there are six pins in this section, the
time of backwash will be 12 min. (2 min. per pin). to
change the length of backwash time, add or remove pins
as required. The number of pins times two equals the
backwash time in minutes. (Note: Do not add pins
before "0" minutes designation)
How To Change The Length of Brine and Rinse
Time:
The group of holes between the last pin in the backwash
section and the second group of pins determines the
length of time that your unit will brine and rinse. (2 min.
per hole.)
To change the length of brine and rinse time, move the
rapid rinse group of pins to give more or fewer holes in
the brine and rinse section. Number of holes times two
equals brine and rinse time in minutes.
SALT LEVEL MUST ALWAYS BE ABOVE WATER LEVEL IN BRINE TANK.
BRINE & RINSE
SECTION
(2 MIN. PER HOLE)
BACKWASH
SECTION
(2 MIN. PER PIN)
How To Change The Length Of Rapid Rinse And
Brine Tank Fill Time:
The second group of pins on the program wheel
determines the length of time that your water conditioner
will rapid rinse and brine tank fill. (2 min. per hole.)
To change the length of rapid rinse and brine tank fill
time, add or remove pins at the higher numbered end of
this section as required. The number of pins times two
equals the rapid rinse and brine tank fill time in minutes.
The regeneration cycle is complete when the outer
micro-switch drops off the last pin in the rapid rinse and
brine tank fill group of pins. The program wheel,
however, will continue to rotate until the inner micro-
switch drops into the notch on the program wheel.
Return timer to closed position engaging snap retainer
in back plate. Make certain all electrical wires located
above snap retainer post.
IMPORTANT!
PROGRAM
WHEEL FOR
CONTROL OF
REGENERATION
CYCLE
PIN STORAGE
RAPID
RINSE &
BRINE TANK
REFILL
SECTION
(2 MIN.
PER PIN)
Page 7