Pentair Fleck 2510 Service Manual page 31

MODEL 2510 & 2510 ECONOMINDER
seal and spacer replacement (continued)
9. Alternately remove the remaining seals and spacers in
accordance with steps No. 6 and 8.
10. The last or end spacer odes not have any holes for the
pins of the spacer tool to engage, therefore if the end
spacer does not come out on the first try, try again
using the wire hook with the finger loop.
11. To replace seals, spacers and end ring, use special
tool with the brass sleeve on one end. This is a
double-purpose tool., (See Fig. 4). The male end acts
as a pilot to hold the spacers as they are pushed into
the valve body and the brass female end is used to
insert the seals into the valve body.
12. To restuff a valve body, first take the end ring (the
plastic or brass ring without holes), then with your
thumb press the button on the brass sleeve end, the
large dia. inner portion is now exposed (See Fig. 4).
Place the end ring on this pilot with the lip on the end
ring facing the tool, and push the tool into the valve
body bore until it bottoms. While the tool is in the valve
body, take a seal and press it into the inside diameter
of the exposed brass female end (See Fig. 5).
13. Remove the tool, turn it end for end and insert it into
the valve body bore. While holding the large dia. of the
tool, slide it all the way into the valve body bore until it
bottoms, then push the center button to push the seal
of the tool and leave it in place in the valve body (See
Fig. 6).
14. Remove the tool from the valve body and push the
center on the brass female end to expose the pilot on
the opposite end. Place a spacer on this end and
insert the spacer and tool into the valve.
INJECTOR
BRINE
TUBE
Figure 3 Removing Spacer From Valve Body
INJECTOR
BRINE
TUBE
Figure 4 Replacing Spacer In Valve Body
SPACER
PULLER
SPACER
STUFFER
Page 31