Setup Menu - Omega HH911T User Manual

The LCD can display error information about the current measurement, as shown in Figure
4.
D
ISPLAY
OPEn
-Or-
-Ur-

Setup Menu

Key designators followed by (1.5s), e.g.
pressed and held for 1.5 seconds, then released to access the desired function.
Measurement settings are configured in the Setup Menu. Press
Menu. The SET annunciator will appear at the bottom of the display and the currently
selected thermocouple type will begin to flash.
From within the Setup Menu, press
the keys to advance or reverse the selected value for the active parameter. The active
parameter value will flash on the display.
Press to save a setting and step to the next parameter. Press
exit the Setup Menu. Press
key is pressed for ten (10) seconds, the current configuration is saved and the instrument
will exit the Setup Menu.
Figure 5 below lists the user-definable parameters and the available values for each
parameter.
To set a parameter value:
1. Press
(1.5s)
2. Press
parameter is reached;
3. To change the value of the current parameter, press
Figure 3: LCD Display Description
D
ESCRIPTION
No thermocouple probe is connected or making connection
Over range: The applied temperature is greater than the maximum
temperature for the selected thermocouple type
Under range: The applied temperature is less than the minimum
temperature for the selected thermocouple type
Figure 4: LCD Error Indications
to disregard unsaved changes and exit the Setup Menu. If no
to enter the Setup Menu;
to cycle through parameters as shown in Figure
Operating Instructions
(1.5s) , indicate that the key should be
to step through the user-definable parameters and
3-3
(1.5s) to access the Setup
to save a setting and
5
until the desired
;