7.
At initial power on after battery replacement, allow approximately 30 seconds for
instrument to stabilize.
Battery
Compartment
Gasket
Making Your First Temperature Measurement
Omega's 900 Series Digital Handheld Thermometers are designed for easy operation, while
still providing a feature-rich experience via the intuitive user interface.
To get started making temperature measurements right away, follow these steps:
1.
Perform Section 2.5, Battery Installation and Replacement;
2.
Connect a compatible temperature probe to the Channel 1 and/or Channel 2 input
connector located at the top of the instrument;
3.
The instrument will immediately display a temperature measurement for the
connected channels. However, to ensure valid and best accuracy measurements,
continue to Step 4 below;
4.
Set the desired measurement parameters as follows:
a.
b.
c.
Figure 1: Battery Installation
To ensure best measurement accuracy, allow several minutes for the
thermocouple probe and connector to thermally stabilize after
connection to the instrument.
Enter the Setup Menu by pressing
approximately 1.5 seconds, and then release it;
The active thermocouple type is flashing on the display. Use
select the thermocouple type of the connected temperature probe (E, J,
K, or T);
Momentarily (do not hold) press
the next parameter;
Preparation for Use
Retaining Screws
, hold the key down for
to save your selection and move to
2-5
to