Temperature Meter Calibration Setup - Omega HH376 User Manual

9. TEMPERATURE METER CALIBRATION SETUP

9.1 Temperature Calibration
Place the temperature probe in a known, stable temperature environment. Allow the readings to
stabilize. In Setup, change the offset until the display reading matches the calibration temperature.
Press and hold
Press button to enter calibration mode. (in 3 seconds)
Press button to enter calibration mode. (in 3 seconds)
Press or
Press button twice to confirm selection.
Note: To abort during the process, press
9.2 Recall Default factory setting value
Press and hold
Press button to enter calibration mode. (in 3 seconds)
Press button to enter recall mode. (in 3 seconds)
Below table diagram shows each button function when user enters
into the calibration mode.
Note:
Turn the Power "OFF" before attempting SETUP.
Setup mode is cancelled during below procedure if "POWER"
button is pressed.
+ buttons and then power on the meter to enter setup mode.
button to confirm present Temperature value.
+ buttons and then power on the meter to enter setup mode.
button to exit calibration mode.
6
RTD THERMOMETER