Auto-Power Off - Omega HH911T User Manual

channel is not connected to a probe, or the current measurement on either channel is over-
or under-range, T1-T2 view mode is not available.
When viewing statistics, the active statistic is indicated directly below the result. The
elapsed time of the current statistics session is displayed in the lower-left corner of the
display.
Statistics are calculated continuously, beginning when the instrument is powered on or when
is pressed. To pause statistics collection temporarily, press
(1.5s)
collection, press
It is important to note that changing parameter values or temperature probes will invalidate
the current statistics session. When using statistics, always begin by pressing
delete existing statistics data and initiate a new statistics session.
Press to step through the available statistics. Statistics are displayed in the order shown
in Figure 7 below. For dual-channel models, the LCD T1 or T2 indicators are lit to identify the
channel's statistics currently being displayed.
When using statistics, always begin by pressing
results and initiate a new statistics session.
The first line of the display indicates the current Channel 1 temperature, regardless of
which view mode or channel's statistic is currently displayed.
M C
ODEL HANNEL
HH911T T1
T1
HH912T
T2
If the instrument records invalid measurement data during the statistics session such as an
over-range, under-range, or open input value,
———— will be displayed for each affected statistic result.
To return to the active measurement mode, press
remaining view modes, or cycle power.

Auto-Power Off

Key designators followed by (1.5s), e.g.
pressed and held for 1.5 seconds, then released to access the desired function.
again.
S V
TATISTIC
MIN MAX
MIN MAX
MIN MAX
Figure 7: Statistics Sequence
Operating Instructions
(1.5s)
S
IEW EQUENCE
AVG
AVG
AVG
repeatedly to step through the
, indicate that the key should be
(1.5s)
3-5
. To resume statistics
(1.5s)
to clear existing statistics
RNG STDEV
RNG STDEV
RNG STDEV
to