View Modes And Statistics - Omega HH911T User Manual

4. To save the current
parameter value and cycle
to the next parameter,
press
(1.5s) ;
5. To save the current
parameter value and exit
the Setup Menu, press
6. To disregard changes
made to the current
parameter value and exit
the Setup Menu, press
If no key is pressed for ten (10) seconds, the instrument will save the current
configuration and exit the Setup Menu.

View Modes and Statistics

The instrument features multiple view modes including a variety of real-time statistics, all
available at the touch of a button. Figure 6 below describes each view mode.
V M
IEW ODE
T1–T2
Minimum
Maximum
Average
Range
Standard
Deviation
Standard Deviation is calculated using the population formula: ���� = �
1
Press to change view modes. For each mode, the active measurement or statistic result
is displayed on the second line of the display.
The T1-T2 view mode displays the current Channel 1 measurement minus the current
Channel 2 measurement. The display indicates T1-T2 at the left side of the display. If either
P
ARAMETER
Thermocouple Type
Temperature Units
T1 Probe Offset
T2 Probe Offset
; Open Wire Detection
Resolution and
Rounding functions
trnd
.
T2 Probe Offset available on model HH912T only.
1
Figure 5: Setup Menu Parameters and Values
D
ISPLAY
D
ESCRIPTION
I
NDICATOR
Current Channel 1 measurement – current
T1-T2
Channel 2 measurement
Minimum temperature recorded during
MIN
current session
Maximum temperature recorded during
MAX
current session
Average of all temperatures recorded during
AVG
current session
RNG Maximum - Minimum
Standard deviation of all temperatures
STDEV
recorded during the current session
Figure 6: View Modes and Statistics
Operating Instructions
1
∑(����−µ)
����
3-4
AVAILABLE VALUES
E, J, K, T
°C, °F, K
±0.1 ° increments
±0.1 ° increments
ON, OFF
rndG, Auto, CEIL, nOrL,
trnC
ON, OFF
1 .
2