Mira Discovery Installation & User Manual page 11

Bracket
600 mm
Wallplug
Flow Regulator
Screw
Bracket Cover
Slide Bar
Clamp Bracket
Assembly
Hose Retainer
Bracket Cover
OR
Washer
1.3. For solid walls drill two 8.0 mm
diameter holes at 600 mm centres
and insert the wall plugs.
Note! Special consideration should
be given to the fixing arrangements
when installing on to a dry lined,
stud partition, shower cubicle or
laminated panel wall structures.
Installers may wish to obtain
alternative proprietary cavity fixing,
or choose other options, however,
these methods of fixing are beyond
the scope of this guide.
1.4. Assemble and fit the Slide Bar,
Clamp Bracket and Hose Retainer
as shown.
1.5. Pass the hose through the hose
retainer and screw onto the outlet of
the shower control. Make sure that
the hose washer is fitted.
Caution! Do not over tighten.
1.6. Place the handset into the clamp
bracket assembly.
Note! If necessary, for high
pressure systems, a 12 litre/
minute flow regulator (supplied)
can be fitted under the hose
washer.
11