Download Print this page
AKO -55326 Quick Manual
AKO -55326 Quick Manual

AKO -55326 Quick Manual

Trapped person alarm push-button.

Advertisement

Quick Links

GB
Trapped person alarm push-button.
Quick guide
AKO-55326
AKO ELECTROMECÁNICA , S.A.L.
Avda. Roquetes, 30-38
08812 • Sant Pere de Ribes.
Barcelona • Spain.
Tel.: +34 902 333 145
Fax: +34 938 934 054
www.ako.com
We reserve the right to supply materials that might vary slightly to those described in
our Technical Sheets. Updated information is available on our website
Warnings
The alarm and pushbuttons must be installed in a place protected from vibrations, water and corrosive
5532H602 Ed.01
gases, where the ambient temperature does not exceed the value indicated in the technical data.
The station must be installed in a place where the regular presence of people who can alert to the presence of alarms
is guaranteed.
Neither the alarm nor the pushbutton are suitable for areas classified as potentially explosive.
The pushbutton must be installed inside the cold room, in a visible place and no higher than 125 cm from the
ground.
Wiring
ALARM STATION
Always disconnect the power supply to do the
Input x
wiring.
The wiring between the pushbutton and the station
must NEVER be installed in a conduit together with
power, control or power supply cables.
Indicator lights
Alarm Pushbutton

Advertisement

loading
Need help?

Need help?

Do you have a question about the AKO-55326 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AKO AKO-55326

  • Page 1 The wiring between the pushbutton and the station must NEVER be installed in a conduit together with power, control or power supply cables. AKO-55326 Indicator lights AKO ELECTROMECÁNICA , S.A.L. Avda. Roquetes, 30-38 08812 • Sant Pere de Ribes. Barcelona • Spain. Tel.: +34 902 333 145 Fax: +34 938 934 054 www.ako.com...
  • Page 2: Technical Specifications

    Configuration Use in: AKO-55424 / AKO-555241 / AKO-555242 / AKO-558241 / AKO-558242 Step 1: Once the pushbutton has been connected, connect the power supply of the station. Before 2 minutes have passed, press the “AUTOCONFIG” pushbutton 5 consecutive times. Step 2: Press the “AUTOCONFIG”...