Install Punch Die Set & Test; Die Maintenance; Die Set Service; Die Set Life Expectancy - Canon imageRUNNER ADVANCE C7580i II Advance Maintenance Manual

Preventative maintenance procedure
Hide thumbs Also See for imageRUNNER ADVANCE C7580i II:
Table of Contents

Advertisement

iRADV C7580i/C7570i/C7565i Advance Maintenance Guide
Procedure
M13
Multifunction Professional Puncher- A1
Install Punch Die Set & Test
Run several sheets of the
customer's paper through
the punch and inspect the
holes
M14
Multifunction Professional Puncher- A1

DIE Maintenance

Detail
To lubricate Die Set pins that do not have felt pads:
1.
Depress the Die Set so that the pins protrude
from the bottom plate.
2.
Apply a drop of high quality machine oil to the
end of each pin.
3.
Wipe clean, leaving a light coat of oil on them.
4.
Oil from the die may blemish the first few
punched sheets after oil has been applied. Run
test punched copies until clean copies can be
made.
To lubricate Die Set pins that have felt pads:
1. Lubricate with a high quality machine oil.
2.
Apply oil lightly along the length of the pad [1],
but do not over saturate.
3.
Do not use spray lubricants because they tend
to dry up quickly and leave sticky residue.
4.
Oil from the die may blemish the first few
punched sheets after oil has been applied. Run
test punched copies until clean copies can be
made.
Note
Set the Die set on a table and press the top plate
[1] straight down at both ends at the same time
and look for a smooth operation. The top plate and
pins should retract fully when you release.

Die Set Service

The Die Set assembly is not serviceable other than
inspection and periodic lubrication. If a Die Set is
at its end of life, it will tend o cause paper jam due
to hanging chips. This is a result of a die plate wear,
and not pin wear, which cannot be corrected.
When this occurs, the Die Set should be replaced
with a new one.

Die Set Life Expectancy

Minimum life expectancy of
750,000
punching when periodic lubrication is performed.
Use the Die Cycles feature on the user interface to
view the number of cycles on the Die Set. Variable
life expectancy due to variety and types of paper,
cover stock being punched and length of avg. job
plus other environment conditions.
Inspect & Lubricate every 200K
Time
Visual Check
1
min
Check
5
min
Test
times of

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents