Advertisement
Attaching the Oar Board® Rower to a Standard SUP without deck rings
Step 1: Mount the unit on the board with the seat end of
the unit at a point about 2 inches behind the lift handle or
balance point of the board, and centered in the middle of
the board. You can fine-tune the location with experience.
*Note - a little extra buoyancy forward makes for better
rowing, especially into waves.
Step 2: Take your Kwik-Lok strap and fold the buckle back on itself so the sticker side is flush against the strap as shown.
Thread the strap through the base of the Oar Board® and around the underside of the board. Once around the board,
thread the strap back through the base of the Oar Board®. Thread the strap under and through the back opening of the
buckle and then down and through the front opening.
Step 3: Hand tighten the strap so that you have to put some pressure on to the buckle to flip it over and close it. The
sticker should now be facing up. *Note - don't tighten straps to the max, only enough so the Oar Board® stays in place.
Tuck the excess end of the strap through the Oar Board® Rower. Simply repeat this procedure with the second strap!
Relieve tension on the straps when not in use. To release simply grip the free end of the strap and pull up keeping your
fingers clear.
Step 4: You are now ready to launch your board and have a great row with your Oar Board® Rower!
See Video online at www.OarBoard.com
Step
Step
Step
Step
Step
Step
Page 6
Advertisement
