Advertisement
®
Oar Board
o not over tighten the buckles
•
some SUP surfaces. Release the buckle's tension or remove the Oar Board ® Rower
from the SUP when not in use to prevent SUP surface printing.
o make sure your foot stretcher pad pins are pushed down all the way into the
•
correct hole before rowing to ensure they don't slip out.
• Keep Oar Board ® tracks clean and free from sand, mud, or crusted salt to prevent
abrasion of the track.
• Make sure your Oar Board ® is e uidistant from the sides on the SUP on all four
corners before rowing (it might slip slightly off center while carrying to the water).
Handy tip: once you're satisfied you have the ideal spot determined for your board,
making some marks or adding some stickers to the board at the four corners of the
unit helps.
• Gaskets: Once your weight is on the unit the added pressure on the four neoprene
gaskets located on the bottom of each corner keep the unit in its centered position.
Remember to replace any gaskets that come off before using your Oar Board ®
Rower.
o not use your Oar Board ® rigger arms to pull the SUP up out of the water. Instead
•
remove the outrigger carriage from the board first, by removing the end stop and
sliding the carriage off the base. Use the Oar Board® seat base to lift and carry the
Oar Board®. Then lift your SUP out of the water using the SUP handles.
ow to set up our
and see the
www.OarBoard.com
• Hose salt water off all surfaces after each use to help keep your Oar Board ® Rower
pristine and prevent salt build up.
hitehall owing
allas oad
anada
h: 2
a : 2
ail:
info whitehallrow com
Tips - Do's and Don'ts
too much tension will produce an indent or print in
ar oard
Sail
ictoria
ower
Video online at
See page 3
Page 11
Advertisement
